The Woodward 5466-348, also cataloged as the 5466-348 NetCon S10 Module, operates as a dedicated hardware component for communication interface management with digital actuator drivers within NetCon 5000 architectures.

Hardware Specifications

Actuator Loop Feedback Response and Thermal Dissipation Profiles

Configured with three discrete RS-485 ports operating at 417 kbaud, the 5466-348 module delivers high-speed cyclic data transmission to digital actuator drivers at a 5 ms update rate. The internal 16-bit processing circuit formats noise-free digital position commands to optimize actuator loop feedback response in turbine governor networks. Automated fault diagnostic logic monitors channel integrity per port, isolating failed driver links while maintaining passive thermal heat sink dissipation profiles across the module assembly.

Frequently Asked Questions

Q: What is the channel update rate for actuator driver links on the 5466-348?

A: The module executes dedicated cyclic updates at a 5 ms update rate per connected driver port.

Q: How does the module handle a driver communication failure?

A: Dedicated fault detection logic continuously monitors line telemetry, flagging communication failures per channel and disabling faulty drivers to protect system operation.

Q: What serial framing parameters are mandated for the RS-485 ports?

A: The three RS-485 UART ports operate at 417 kbaud using 8 data bits, no parity bit, and 1 stop bit.

Field Installation Guidelines

• Ensure backplane power is de-energized prior to inserting or seating the 5466-348 card in the NetCon chassis.
• Use low-capacitance, shielded twisted-pair cabling for all 417 kbaud RS-485 communication channels.
• Ground all cable shields directly to the main rack earth bar to prevent high-frequency common-mode noise corruption.
• Observe standard RS-485 line termination resistor requirements on long wiring runs to maintain signal integrity.